This week we focused on our 3D print wearable items, My Idea of course were the hats for worms, My first draft didn’t go so well, it was either too tight to wear or too big to wear, so I went back into the file and changed the finger width to be 0.6 inches, so that the tip of your finger could go in and wear the hats, here is the finished product:
I then had to work on some feedback on my critique of the recipe spread, It was really just small things like don’t make sentences too long, don’t fill up space if you need to, have visual cohesion etc. Here is my updated draft:
VIEW IN TWO PAGE MODE